CAN-AM DEFENDER MAX INSTRUCTIONS
1.USE 1 ½” HOLE SAW BIT TO DRILL HOLES ON SIDE PANELS USING THE FACTORY INDENTATIONS ON PLASTICS AS YOUR GUIDE (NOT PROVIDED)
2. INSTALL TREE KICKERS AND DETERMINE WHAT RIVEST UNDER SXS NEED TO BE DRILLED OUT
3. USING A 3/16 DRILL BIT DRILL OUT RIVETS
4. LOOSEN GAS TANK STRAPS AND MOVE/SLIDE GAS TANK BACK, HOSES MUST BE REMOVED ALSO
5. INSTALL TREE KICKERS, PUTTING TOP BRACE ON FIRST THEN SLIDING PLATES UNDER THE SXS, MAKE SURE THE PLATES SLIDE UNDER THE SKID PLATE
6. THREAD BOLTS THROUGH SXS FRAME AND INTO TOP BARS OF TREE KICKERS USING FLAT WASHERS AND LOCK WASHERS PROVIDED
(3/8-16 X 2 ½”)
7. MAKE SURE HOLES ARE LINED UP ON BOTTOM OF SXS, INSTALL NEW RIVETS PROVIDED AND RIVET IN
8. TIGHTEN ALL HARDWARE 